Replacing the Lamp / Bulb in the UF55 and UF65 Projectors

Replacing the Lamp / Bulb in the UF55 and UF65 Projectors.

To remove the lamp cover and lamp module – (Projector does not have to be removed from the boom. Image is shown upside down.)

  1. Pull off the outer lamp cover and set it aside.

  1. Loosen the two screws on the inner lamp module with a Phillips No. 2 screwdriver. The screws remain captive inside the lamp module.

Caution

If you do not remove the projector from its boom, the lamp module can fall out of the projector when you loosen its screws. Hold onto it carefully when you loosen the screws.

  1. Pull up on the lamp module’s handle, and then remove the lamp.

  1. Gently place the lamp module on your work area with the handle facing downward.

 

 

To replace the lamp module and lamp cover

  1. Place the lamp module back in the lamp slot, push the lamp all the way down, and then tighten the lamp locking screws until they’re secure.
  2. Replace the outer lamp cover in its original position. Notes

 

Last Update: April 7, 2017  

April 7, 2017   167   wiz    Projector  
Total 0 Votes:
0

Tell us how can we improve this post?

+ = Verify Human or Spambot ?

Add A Knowledge Base Question !

You will get a notification email when Knowledgebase answerd/updated!

+ = Verify Human or Spambot ?

About The Author

Network Engineer / Technology Specialist for Wayne County Schools.

I have worked in technology in the school system since the mid 90’s.

Related posts