Calibrating a SmartBoard

Problem

If, when touching your Smart Board with your hand or with a pen, it shows up to the left, right, top, or bottom of the intended target, you need to realign it.

Solution

Make sure your computer and projector are turned on.  Locate the two buttons shown in the picture below and press and hold down the two buttons on the tray until a screen pops up with 9 points.

Carefully click on the center of each point as they are presented to you.

After calibrating the board, if the spot where you touch the screen is still not correct then try the following.  Press and hold the reset button (the bottom button on the right side of the board) and repeat the above process.

Last Update: September 1, 2017  

May 17, 2016   297   wiz    SmartBoard  
Total 0 Votes:
0

Tell us how can we improve this post?

+ = Verify Human or Spambot ?

Add A Knowledge Base Question !

You will get a notification email when Knowledgebase answerd/updated!

+ = Verify Human or Spambot ?

About The Author

Network Engineer / Technology Specialist for Wayne County Schools.

I have worked in technology in the school system since the mid 90’s.

Related posts